When enabled , removable media devices, such as CD drives, are supported. Some events are not stored indefinitely. When enabled , the controller automatically rebuilds an array when a failed disk drive is replaced. The default setting is Auto , which allows the SAS card to adjust the data transfer rate as required. Set to No disabled only if the controller is connected to a device that does not support CRC Checking. During bootup, if your system has insufficient memory, the following message appears. Select the array that you want to make bootable, and then press Ctrl-B.

Uploader: Gojind
Date Added: 26 January 2012
File Size: 18.38 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37832
Price: Free* [*Free Regsitration Required]

Select Yes to exit, then press any key to restart your computer.

Select the Select utility and press Enter. It contains the following sections:. Select the array that you want to make bootable, and then press Ctrl-B.

Adaptec All Drivers | DriverZone

Initializing a disk drive that is part of an array might make the array unusable. Default setting is Yes enabled. This is normal behavior. Note that there might be a significant performance reduction. The place to find device driver updates.

Note – Failed drives are displayed in a different text color. To return to the main ACU menu after the secure erase has started, press Esc. When enabledthe controller automatically rebuilds an array when a failed disk drive atray1000 replaced.


When enabled, NCQ is enabled. The size of the disk drive.

Note – New disk drives are low-level formatted at the factory and do not need to be low-level formatted again. From the Manage Arrays menu, do any of the following:.

When disabled, the array must be rebuilt manually.

When enabled, determines whether the controller verifies the accuracy of data transfer on the serial bus. Instructions for completing tasks are displayed onscreen.

Displaying the disk drives adds a few array100 to the overall POST time. Follow the onscreen instructions to create and manage arrays, and initialize, rescan, and erase disk drives.

Select Controller Configuration from the main Select utility menu and change the settings listed in the following arrray1000. You can identify disk drives by viewing the list of disk drives on your system. Also, when the log is full, new events overwrite old events. Check the BIOS settings to verify the correct boot order. The event log is cleared of any non-persistent events each time you restart your computer.


The selected disk drive array100 cannot be used until the erase is complete. The Disk Utilities view displays the following information:.

Some events are not stored indefinitely. The array number changes to Array 00, which makes the array the boot array.

Adaptec – AROU2

Only disk drives that can be used in a new array are available for selection. Select the disk drive you want, then press Enter. The utility addaptec the following information about the status of the battery. You can use the disk utilities tool to perform low-level formatting, or to verify your disk drives. In a situation where adaptex want each phy on a controller to be in a different SAS domain, this setting specifies a unique world-wide name for each phy.

Caution – Before deleting an array, back up the data to avoid permanently losing it.

Author: admin